- antenna
-
A device, typically mounted inside the exciter enclosure, which helps facilitate wireless communications between the Brush Condition Monitoring System and the Brush Health Sensors.
- antenna placement mode
-
An optional mode included in the Brush Condition Monitoring System which displays the wireless signal strength of each sensor in or order to assist in successful placement of the antenna.
- auxiliary display
-
An optional, secondary enclosure of the Brush Condition Monitoring System which consists of a fully-functioning duplicate display of the primary controller.
- Brush Condition Monitoring System
-
A Cutsforth EASYchange® monitoring system that performs automated measurements and brush health analytics that allow plant operators to improve the efficiency of technicians’ daily and weekly tasks by dispatching them to the collector when maintenance is actually needed.
- Brush Health Sensor (BHS)
-
A wireless sensor integrated into the brush spring which communicates with the Brush Condition Monitoring System.
- primary controller
-
The main enclosure of the Brush Condition Monitoring System, which contains the computer and power supply as well as the main touchscreen interface.
A device, typically mounted inside the exciter enclosure, which helps facilitate wireless communications between the Brush Condition Monitoring System and the Brush Health Sensors.
An optional mode included in the Brush Condition Monitoring System which displays the wireless signal strength of each sensor in or order to assist in successful placement of the antenna.
The reduction of the amplitude of a signal due to excessive cable length.
An optional, secondary enclosure of the Brush Condition Monitoring System which consists of a fully-functioning duplicate display of the primary controller.
American Wire Gauge
A Cutsforth EASYchange® monitoring system that performs automated measurements and brush health analytics that allow plant operators to improve the efficiency of technicians’ daily and weekly tasks by dispatching them to the collector when maintenance is actually needed.
A wireless sensor integrated into the brush spring which communicates with the Brush Condition Monitoring System.
Distributed Control System
Lockout/Tagout
Modbus Remote Terminal Unit
Modbus Transmission Control Protocol
The main enclosure of the Brush Condition Monitoring System, which contains the computer and power supply as well as the main touchscreen interface.