1. Cutsforth Support
  2. InsightCM™ iOS Apps
  3. InsightCM™ iOS Apps Support Articles

How to Power On Your Route-Based Sensor/Device

Follow

Sensor-Works bluVib

The bluVib sensor is activated using a magnet. Follow the steps below to turn on your sensor:

  1. Hold your magnet near the top of the bluVib sensor.

  2. Swipe the magnet around the top of the sensor.

  3. The sensor will power on.

image1.gif

NOTE:

The bluVib sensor will remain powered on as long as it is connected to the iOS app. The sensor will automatically power off when disconnected.

TPI-9043

The TPI-9043 uses a dedicated power button to turn the device on and off.

Turning On

  1. Locate the power button on the device.

  2. Press and hold the power button for 1–2 seconds.

  3. The power LED will illuminate to confirm the device is on.

Turning Off

  1. Press and hold the power button.

  2. Continue holding until the power LED turns off.

  3. The device is now powered off.

image2.png
Was this article helpful?
0 out of 0 found this helpful

Articles in this section