Related Products:

EGSA-310, EGSA-320

Related Documents:





Signal Cable, Conduit, Circular Plug Screw Connector


Describes how to install the signal wire.

Install the Signal Cables

  1. Open up the signal wire disconnect condulet (A) to expose the internal Ethernet ports. Connect the Ethernet signal cables to the ports according to the wiring diagram associated with your equipment. Close the signal wire disconnect condulet (A) .

  2. Route the signal cables (B) to the intended monitoring system location through conduit (provided by the electrical contractor). 

    Refer to your specific monitoring system operations manual for further instructions on wiring and  mounting the monitoring system.


Related Articles

Installation Overview

Do you need more help?

Was this article helpful?
0 out of 0 found this helpful