Related Products:

EGSA-310, EGSA-320

Related Documents:





Securing, Tightening, Torquing


Describes how to secure the rope guide in place.

Securing the Rope Guide

  1. Adjust each rope guide section so that the contact points (A) are touching the 1/16 in rope guide spacer.

  2. Tighten all the 5/16 in-18 x 5/8 in bolts (hex head or IP40 Torx button head) (B) on the rope guide starting closest to the attachment arm side of the assembly, and then work around from there. Torque all the bolts to 220 in lbs.

  3. When all rope guide bolts are torqued and the rope guide is secured, remove the rope guide spacer.


Related Articles

Installation Overview

Do you need more help?

Was this article helpful?
0 out of 0 found this helpful