Installing Adapters on the Yokes

Align the first two adapters, one with cross hole threads  and one without , with the holes on each side of the yoke . Align the adapters with the mount side facing the center of the yoke.

Install the adapters at the first, fourth and seventh set of holes starting from the outside of the yoke.

Secure the adapters using NL8 Nordlock washers  and 5/16-18 x 4 in bolts .

Torque to 220-240 in lbs (25-27.5 Nm).

Repeat steps 1 through 3 for the next four adapters on the same side of the yoke.

On the opposite side of the yoke, align and attach the adapters facing the opposite direction of the first three adapter pairs.

Repeat steps 1 through 5 for the second yoke.