1. Cutsforth Support
  2. Shaft Ground Monitoring: Assurance System | Series 1
  3. Operations

Shaft Voltage Test Point

Follow

Related Products:

EGSK-301, EGMA-301

Related Documents:

EZDP-2041

Type:

Operation

Keywords/Labels:

Assurance Monitoring, Operations

Summary:

Procedure for reading the shaft voltage.

ELECTRICAL DANGER

Only qualified electrical personnel should take measurements at the remote test points. For any of the test points on the faceplate, use a hand-held voltmeter, oscilloscope, clamp-on ammeter, or other appropriate testing device. Always follow proper electrical safety procedures.

Shaft Voltage Test Point

The + and - shaft voltage test points connect directly to the following points:

  • + is the isolated meter rope on the shaft.

  • - is case ground.

To read the shaft voltage

Place the positive and negative probes on the Shaft Voltage “+” and “-“ test points, respectively.

The resulting voltage or waveform read at this point represents the shaft voltage at the metering rope location.
Shaft_Voltage_Test_Points.png

Do you need more help?

Submit your questions or requests using the Support Ticket Submission form.

Was this article helpful?
0 out of 0 found this helpful

Articles in this section