1. Cutsforth Support
  2. Shaft Ground Monitoring: Remote Meter Point | Series 2
  3. Operations

Rope Wear Indicator LED

Follow

Related Products:

EGSK-201, EGMA-203

Related Documents:

EZDP-2046

Type:

Operation

Keywords/Labels:

Remote Meter Point, Operations

Summary:

Procedure to test for a worn rope.

Safety Notices

ELECTRICAL DANGER

Only qualified electrical personnel should take measurements at the remote test points. For any of the test points on the faceplate, use a hand-held voltmeter, oscilloscope, clamp-on ammeter, or other appropriate testing device. Always follow proper electrical safety procedures.

Rope Wear Indicator LED

To test for a worn rope

Press the button at the bottom of the faceplate to illuminate the rope wear indicator LED at the center of the faceplate:

GRMRWI.png
Pushbutton_Test_Point.png

  • If the LED illuminates green, the ropes are not yet in need of replacement.

  • If the LED illuminates red, one or both of the ropes is worn to the point of needing replacement.

Do you need more help?

Submit your questions or requests using the Support Ticket Submission form.

Was this article helpful?
0 out of 0 found this helpful

Articles in this section