1. Cutsforth Support
  2. Shaft Ground Monitoring: Remote Meter Point | Series 2
  3. Operations

Shaft Voltage Test Point

Follow

Related Products:

EGSK-201, EGMA-203

Related Documents:

EZDP-2046

Type:

Operation

Keywords/Labels:

Remote Meter Point, Operations

Summary:

Procedure for reading the shaft voltage.

Safety Notices

ELECTRICAL DANGER

Only qualified electrical personnel should take measurements at the remote test points. For any of the test points on the faceplate, use a hand-held voltmeter, oscilloscope, clamp-on ammeter, or other appropriate testing device. Always follow proper electrical safety procedures.

Shaft Voltage Test Point

To read the shaft voltage

Place the positive and negative probes of an oscilloscope or digital voltmeter on the SHAFT VOLTAGE and SIGNAL COMMON [GROUND] test points, respectively.

shaft-voltage-TP.png

The resulting voltage or waveform read at this point represents the shaft voltage at the metering rope location.

Do you need more help?

Submit your questions or requests using the Support Ticket Submission form.

Was this article helpful?
0 out of 0 found this helpful

Articles in this section