1. Cutsforth Support
  2. Shaft Ground Monitoring: Premium Monitoring | Series 1 & 2
  3. Maintenance

Visually Inspect and Clean Premium Monitoring System Electrical Components

Follow

Related Products:

EGMA-004, EGMA-005, EGMA-006, EGMA-007, EGMA-008, EGMA-013, EGMA-015, EGMA-016, EGMA-019

Related Documents:

EZDP-2020 and EZDP-2038

Type:

Technical information

Keywords/Labels:

Premium Monitoring System, Calibration, Set up, Maintenance

Summary:

Advised cleaning frequency and instruction for Premium Monitoring System electrical components for preventative maintenance.

Safety Notices

ELECTRICAL DANGER

Calibration and maintenance is to be conducted only by qualified electrical and monitoring systems personnel.

ELECTRICAL DANGER

Follow all plant safety and lock-out/tag-out requirements before accessing the equipment referenced in these procedures.

Calibration and Preventative Maintenance

Visually Inspect and Clean Premium Monitoring System Electrical Components

PM Need: Required

Frequency: Annually

Action: Using a compressed-air duster approved for electronics, blow all dust and debris off the electrical components inside the Premium Monitoring System.

ELECTRICAL DANGER

You need to remove the internal faceplate cover, which includes the touch screen monitor and the remote meter test points.

To access Premium Monitoring System components:

  1. Pause monitoring.

  2. Exit the Premium Monitoring System Application.

  3. Turn off the blue Power switch.

  4. Remove the remote meter points panel to gain access to the AC breaker and turn it off.

  5. Visually inspect and air clean the monitoring system components. Remove the remaining faceplate with monitor only if conditions present require it.

Do you need more help?

Submit your questions or requests using the Support Ticket Submission form.

Was this article helpful?
0 out of 0 found this helpful

Articles in this section